產品中心
                  新聞動態 當前位置:首頁>新聞動態>新聞動態

                  操作過程

                  網址:www.newbalance574soldes.com  2020-12-04  作者:admin    閱讀:

                  操作過程
                  Operation process
                  1.接通電源,打開冷卻水閥門,按下正轉起動按鈕,即可轉動進給手柄,向工件方向進給實現切削,當剝肋長度達到要求時,剝肋刀自動張開,轉動手柄繼續進給,即可實現滾軋螺紋,當滾絲輪與鋼筋接觸時一定要用力,并使主軸旋轉一周。軸向進給一個螺距長度,當進給到一定程度后,即可實現自動進給,直到整個滾軋過程完成后自動停車,按下反轉起動按鈕,即可實現自動退刀。
                  1. Turn on the power supply, open the cooling water valve, and press the forward rotation start button to rotate the feed handle to feed the workpiece to realize cutting. When the rib stripping length reaches the requirements, the rib stripping cutter will open automatically and rotate the handle to continue feeding. When the thread rolling wheel contacts with the reinforcement, make sure that the spindle rotates for one cycle. Axial feed a pitch length, when the feed to a certain extent, automatic feed can be achieved, until the whole rolling process is completed, automatic stop, press the reverse start button, automatic tool withdrawal.
                  2.當自動退刀結束后順時針轉動進給手柄,將滾軋頭退回到初始位置,此時剝肋刀自動復位。卸下加工完成的工件即可。
                  2. When the automatic tool withdrawal is finished, turn the feed handle clockwise to return the rolling head to the initial position, and the rib stripping cutter will automatically reset. Remove the finished workpiece.
                  3.用環規檢查螺紋長度,誤差在范圍內為合格;同時用螺紋通止規檢查絲頭尺寸,通規能旋入,止規不能旋入或不能完全旋入為合格。
                  3. Check the length of thread with ring gauge, and it is qualified if the error is within the range; at the same time, check the size of thread head with thread go / no go gauge, and it is qualified if the go gauge can be screwed in, and the non-stop gauge cannot be screwed in completely.
                  4.滾軋反絲時,先將滾軋頭中的滾絲輪任意兩個互換位置;再將行程開關壓塊前后互換位置,并保證行程不變。
                  4. When rolling the reverse wire, first exchange any two positions of the rolling wheel in the rolling head, and then change the position of the travel switch block before and after, and ensure that the stroke is unchanged.

                  返回新聞

                  轉讓電話
                  13313028229

                  日日摸夜夜添夜夜添无码国产